Elenco Electronics K-34 Manual de Instruções

ONE BUTTON BANDIT KITMODEL K-34Assembly and Instruction ManualElenco™ Electronics, Inc.Copyright © 1989 Elenco™ Electronics, Inc. Revised 2002 R

-9-FINAL ASSEMBLY (CONTINUED)Plastic SpacersPlastic Spacers2-56 Nuts2-56 NutsPC BoardFigure J1. In electronics, a capacitor is a . . .a) counter. c) l

SCHEMATIC DIAGRAM-10-

Elenco Electronics, Inc.150 W. Carpenter AvenueWheeling, IL 60090(847) 541-3800http://www.elenco.come-mail: [email protected]

PARTS LISTIf you are a student, and any parts are missing or damaged, please see instructor or bookstore.If you purchased this One Button Bandit kit f

The One Button Bandit is better known in Las Vegasas the One Arm Bandit. Our device has no arms,but instead a button. Therefore, we call it the OneBut

-3-THE CLOCK OSCILLATORThe clock oscillator is an electronic circuit that putsout a series of high and low voltages. It is a squarewave oscillator who

-4-IntroductionThe most important factor in assembling your K-34 One Arm Bandit Kit is good soldering techniques. Using theproper soldering iron is of

ASSEMBLE COMPONENTS TO THE PC BOARD-5-Figure AElectrolytic capacitors have polarity. Be sureto mount them with the negative (–) lead(marked on side) i

Mount the battery holder and the buzzer to thePC board using three 2-56 x 5/16” screws, three2-56 nuts, and three flat washers (as shownbelow). Note:

Put the 9V alkaline battery into the battery holder.Slide the switch to the ON (top) position and pushon the button switch. The LEDs will flash ON an

-8-2. Next, cut out the holes on the clam shell asshown in Figure H. To do this, you’re going tohave to position the cover sheet inside theclamshell t